Pipe elbow miter cut formula any degree one cut

Formula for Miter Cut Pipe Elbow in One Cut

Marking is to be done in two different pipes, how will the miter band mark in one cut

Marking is to be done in two separate pipes, how will the miter band mark in one cut?

In whatever degree you want to do meter cutting, the degree has to be divided by two.

After answering tan( degree  ) × pipe’s OD answer is 2 , then you will get the back cut of the pipe

According to the 57 mm answer, you can mark in four center lines but

It does not have the correct marking so you have to mark in 8 center line or 16 center line For that, it is shown in the footage how to do the marking in the 16 center line

You can also mark 8  center line and 16 center line and 32 center line, for that you have to

sine will be needed in calculator you will see that a sine is theta then you will select it and

In that you will put degree as much as taking degree position

So friend this marking is done in 16 center line and 90 degree elbow has been made of miter band pipe